Custom Carbon Freeze Chamber
Instructions:
1) Test the lights and make sure that everything lights up.
2) Disassemble the playset if already assembled. Do not put the carbon-freeze block inside the playset and leave out the orange front cover, gun and control panels (top and bottom).
3) Separate top chamber part from the rest of the playset. Set aside the playset without the top chamber.
4) Turn top chamber upside down.
5) Cut fishing line with length as long as the Xmas lights.
6) Start with the first light nearest the plug. Tie a knot with the wire close to the first light into the top right part of the chamber just below the part of the stairs. Tie it tightly, do a double knot if you have to or you'll find out that the knot gets loose as you progress into the next light. This is where it gets tedious because the fishing line is long and you'll have to tie the lights into the slots of the chamber.
7) Tie the first light into the slot of the chamber. Keep the wire spacing as tight as possible. Proceed to the next light and repeat step. Up to ten lights should cover the right side of the chamber.
8) Continue to tie the lights through the middle part going around to the left side of the chamber.
9) Continue to tie the lights around the left side. Up to ten lights should also cover the left part of the chamber. At this point you've made your way back to the stairs on the opposite side of where you started.
10) Make sure that the inner part of the chamber is clear of any lights or wiring. Otherwise you'll have a problem when you need to assemble the top part.
11) Continue to tie the lights around the stairs. Ten lights should cover the whole stairway. At this point you're back on the right side of the stairs where you started. Tie a knot tightly with the stairs and cut out the remaining fishing line.
