Custom Carbon Freeze Chamber
12) If you've followed the instructions carefully, your work should look like the next picture.
13) Drop the wire alongside the chamber wall. Unfortunately one light would show up outside the chamber. But this is a little inconvenience that you can just cover up if you want to. In my case I had it just at the bottom of chamber which is easily covered up when the bottom control panel is placed. Tape the wires to the wall.
14) Run the wire to the bottom of the chamber and place the remaining lights inside the chamber. Tape up the wires inside the chamber and make sure that it doesn't get in the way of the carbon freeze block mechanism. It's a tight fit but if you do it right like I did, you can have the lights inside and the mechanism will work as well. Test it out with the block making sure that none of the wiring gets in the way.
15) Assemble the playset with the top chamber. Make sure that the wiring does not get in the way of the chamber assembly. Put the orange front cover of the playset and the remaining parts as well.
16) Turn on the power and enjoy your own lighted carbon freeze chamber.
